E1 is sensor error. Recheck your connections.Are all the wires tight? Are
they in the right ports? Is the probe seated correctly in the boiler? Were
any of the connecting wires burnt? Ira is usually very good at trouble
shooting this problem. Contact him directly.

On Wed, Sep 2, 2009 at 7:42 PM, ken k <[email protected]> wrote:

>
> With the help of Barry L and Rob C, I replaced my controller.  (I had
> left a few voicemail messages at WLL tech support and sent an email to
> Todd, but had no response, so I ordered a generic one from Canada
> yesterday, which arrived today.)  I set it up with parameters which
> were provided by Barry and Rob (only minimally different).  After the
> unit overheated and gave me an E1 error, I replaced the temperature
> probe with a new one, but the same E1 error code appeared.  Oy!!
>
> So, where do I go from here?
>
> Here are the parameters that I was given:
>
>
> C0= -5               CO -7
> C1=  1               C1   99  (I think this is in error, as the
> parameter only goes up to 20)
> C2=  99             C2  99
> C3 =  -45           C3 -50
> C4 =  1              C4  0
> C5 =  0              C5  0
> C7 =  0              C7  0
> C8 =  1              C8  1
> d0 =  1               DO 1
> d1 =  0               D1   0
> d2 =  2               D2  2
> d3 =  5               D3  5
> L5 =  0               L5  0
> L6 =  0               L6  0
> PU =  0              PU 0
> P0 =  0              PO 1
> P1 - P7 =  0       P1-P7    0
>
> These are all pretty close except for the C0 and the C1 values
>
> Does anyone have any thoughts about what could be wrong?  I find it
> hard to believe that two major things went wrong at the same time, but
> I am wondering if, in fact, they are related..
>
> Thanks!
> Ken K
>
> My apologies if this is similar to what I thought I had posted earlier
> but which did not show up after a couple of hours.... at least this
> one has the values for the controller parameters...
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> >
>

--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"Brewtus" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/brewtus?hl=en
-~----------~----~----~----~------~----~------~--~---

Reply via email to