Folks In developing firmware for the ROACH2 mkid adc, I was checking the pins that get assigned to the ADC, ZDOK interface.
I think there are two pin out errors in the file: hw_routes_roach2rev1.mat I am looking at the included tables for zdok1_p, and so far have found two errors. One pin is for a zdok0 pin, and another is out of order. I am not done with this yet. This is a "heads up." When I figure out what to do about this, I will post again. Also, I have a rev2 roach2 board. I assume that rev1 and rev2 have the same FPGA pinout. Or at least I hope so. Tim Madden Argonne Laboratory
