For ADC16x250-8 efforts relative to the different Roach2, and Roach1, revisions I found these files to be helpful https://casper.berkeley.edu/wiki/images/2/2d/Host_clock_pins_2013feb05.txt https://casper.berkeley.edu/wiki/images/7/70/Pins_diff_rev_2_2013mar29.pdf https://casper.berkeley.edu/wiki/images/6/6e/ZDok_pins_diff_rev2_2013apr24.pdf
On Wed, Apr 29, 2015 at 8:02 AM, Primiani, Rurik <[email protected]> wrote: > Hi Tim, > > The rev2 and rev1 pinouts are *not* the same; specifically some ZDOK pins > were changed likely the "errors" you have found. > > You should not be using "hw_routes_roach2rev1.mat" if you have a rev2. You > should be using "hw_routes.mat". > > Best, > Rurik > > On Wed, Apr 29, 2015 at 10:58 AM, Madden, Timothy J. <[email protected]> > wrote: >> >> Folks >> >> In developing firmware for the ROACH2 mkid adc, I was checking the pins >> that get assigned to the ADC, ZDOK interface. >> >> I think there are two pin out errors in the file: >> >> hw_routes_roach2rev1.mat >> >> I am looking at the included tables for zdok1_p, and so far have found two >> errors. >> One pin is for a zdok0 pin, and another is out of order. I am not done >> with this yet. >> This is a "heads up." >> >> >> When I figure out what to do about this, I will post again. >> >> Also, I have a rev2 roach2 board. I assume that rev1 and rev2 have the >> same FPGA pinout. Or at least I hope so. >> >> Tim Madden >> Argonne Laboratory >> >
