Wow- Thanks for telling me! That would be a mess.
Tim Madden ________________________________ From: Primiani, Rurik [[email protected]] Sent: Wednesday, April 29, 2015 10:02 AM To: Madden, Timothy J. Cc: [email protected] Subject: Re: [casper] ROACH2 FPGA Pinout Problems Hi Tim, The rev2 and rev1 pinouts are *not* the same; specifically some ZDOK pins were changed likely the "errors" you have found. You should not be using "hw_routes_roach2rev1.mat" if you have a rev2. You should be using "hw_routes.mat". Best, Rurik On Wed, Apr 29, 2015 at 10:58 AM, Madden, Timothy J. <[email protected]<mailto:[email protected]>> wrote: Folks In developing firmware for the ROACH2 mkid adc, I was checking the pins that get assigned to the ADC, ZDOK interface. I think there are two pin out errors in the file: hw_routes_roach2rev1.mat I am looking at the included tables for zdok1_p, and so far have found two errors. One pin is for a zdok0 pin, and another is out of order. I am not done with this yet. This is a "heads up." When I figure out what to do about this, I will post again. Also, I have a rev2 roach2 board. I assume that rev1 and rev2 have the same FPGA pinout. Or at least I hope so. Tim Madden Argonne Laboratory
