Hi Tim, The rev2 and rev1 pinouts are *not* the same; specifically some ZDOK pins were changed likely the "errors" you have found.
You should not be using "hw_routes_roach2rev1.mat" if you have a rev2. You should be using "hw_routes.mat". Best, Rurik On Wed, Apr 29, 2015 at 10:58 AM, Madden, Timothy J. <[email protected]> wrote: > Folks > > In developing firmware for the ROACH2 mkid adc, I was checking the pins > that get assigned to the ADC, ZDOK interface. > > I think there are two pin out errors in the file: > > hw_routes_roach2rev1.mat > > I am looking at the included tables for zdok1_p, and so far have found two > errors. > One pin is for a zdok0 pin, and another is out of order. I am not done > with this yet. > This is a "heads up." > > > When I figure out what to do about this, I will post again. > > Also, I have a rev2 roach2 board. I assume that rev1 and rev2 have the > same FPGA pinout. Or at least I hope so. > > Tim Madden > Argonne Laboratory > >
