BJ?
--- Begin Message ---
Replies to this message are sent to The Chevelle Mailing List
------------------------------------------------------------
I'm pretty sure that you can, but you must use a matching rotor (11").
The only question is the ball joint that was used in 80, but I'm almost
positive that TA used the same taper BJ as a b-body. Your best bet,
is call global west & talk with Doug. Or hotchkis if you want to use
theirs. I had a couple of questions when I installed his system and
doug went out of the way to make sure that I understood everything.
What is your ultimate goal? I know of someone who was successful in
swapping to tall spindles without using either GW or hotchkis control
arms. He has a web site detailing everything.
rick
On Sun, 10 Mar 2002 01:48:57 EST [EMAIL PROTECTED] writes:
>
> Replies to this message are sent to The Chevelle Mailing List
> ------------------------------------------------------------
>
> So, can I use the WS6 spindles of a I think 79 or 80 TA?
> Would this be considerred the same type of spindle you mentioned
> earlier in
> the topic? If so I have access to these types.
>
>
> P. Hernandez
> 68 chevelle
>
> -----------------------------------------------------
> To Unsubscribe please visit www.chevelles.net/list.html
> To start a new topic, send mail to: [EMAIL PROTECTED]
-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]
--- End Message ---
