Re: [Chevelle-List] Outboard axle bearing going out?

[Galen and Melissa Love]

Thanks a lot for the info, it sounds like my axle endplay may not be out of reason. ----- Original Message ----- From: Rob To: [EMAIL PROTECTED] Sent: Wednesday, May 29, 2002 12:31 AM Subject: Re: [Chevelle-List] Outboard axle bearing going out? .... dont know what year rear-end yours is but, some G.M. rears call for up to .060(60 thousands)play..... pull the cover,cross shaft,c-clips, then the axle and inspect the bearing surface of the axle for "ANY" wear....                            Rob Means "be good,if not,be good at it     [EMAIL PROTECTED] ----- Original Message ----- From: Galen and Melissa Love To: [EMAIL PROTECTED] Sent: Tuesday, May 28, 2002 8:18 PM Subject: Re: [Chevelle-List] Outboard axle bearing going out? John, I just looked it over, and I don't see any sign of a leak.  What you said about the noise changing when you turn makes sense, but it sure seems pretty clearly like the sound is coming from the left rear.    The other thing that would seem to point to the rear axle would be that the sound increases substantially under hard acceleration (when the rear axle is loaded).  What do you think about the endplay that I mentioned, do you know if that is within the spec?   Thanks again for your help, Galen ----- Original Message ----- From: John Nasta To: [EMAIL PROTECTED] Sent: Tuesday, May 28, 2002 10:10 PM Subject: RE: [Chevelle-List] Outboard axle bearing going out? Galen, usually if the bearing is bad the seal will go bad as well because of the extra pressure on the seal (it will get knocked out of round). Look for leaking axle grease.   Usually if the noise changes when you turn, it is a front bearing.   John Nasta     -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Galen and Melissa Love Sent: Tuesday, May 28, 2002 10:54 PM To: [EMAIL PROTECTED] Subject: [Chevelle-List] Outboard axle bearing going out?   Hey guys, I could use some help.  I've got a noise in my rear axle.  It sounds like it's coming from the vicinity of the left rear brake, and I notice it most when I'm accelerating from low speed, especially when turning in either direction.  Most of the time it's a pretty mild noise, like there is a piece of something loose in the brake mechanism; but on occasion (especially if I try to accelerate hard), it will be a hard clunking noise with each revolution of the rear axle.   I pulled the left rear wheel off tonight and checked the brake out.  It appears fine, I can't find anything that has come loose that might be causing the noise.  I was trying to think of what else it might be, and I began wondering about the outboard axle bearing.  I did a rough endplay check on the left axle shaft, and I'm getting about 1/16" (0.0625") endplay.  This seems pretty loose to me, but I don't have a repair manual to know whether or not this is reasonable.  Does anyone know what the endplay spec is for a 12-bolt rear end?    Thanks in advance, Galen