Cool thanks that's what I thought otis
Joe Freeman wrote: > If they're dropping IMA T1's to an M13 mux on each end of the ChDS3, > and going into an IMA card on the router, then that will work. > > The PA-MC-T3 cards and variants can't do ATM in any flavor, though. > > Joe > > On 8/28/07, *OCOSA ListAcct* <[EMAIL PROTECTED] > <mailto:[EMAIL PROTECTED]>> wrote: > > Ok. I spoke with AT&T earlier they said that they have other customers > taking some T1 IMAs over a channelized DS3 into the same router I was > like how they said they would have a tech contact me I was ok. I > thought > maybe take the DS3 circuit into some sort of mux and split the signal > from the IMA and send to a cross connect and then to the PA-A3-8T1IMA > card....Can anyone shed some light here? Any help is appreciated! > > Otis > > Joe Freeman wrote: > > PA-MC-T3 cards won't do IMA. > > > > That said... Does anyone have any suggestions for scaling NxDS0 > > circuits muxed to ChDS3 in a 7206 chassis beyond 12 DS3's? > > > > Joe > > > > On 8/28/07, *OCOSA ListAcct* <[EMAIL PROTECTED] > <mailto:[EMAIL PROTECTED]> > > <mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>>> wrote: > > > > Has anyone took a channelized DS3 circuit using a (PA-MC-T3) and > > place a > > T1 IMA circuit for dsl aggregation on that same circuit > filling up > > four > > full T1 slots? Would this be a layer 2 local switching setup > on the > > pa-mc-t3 card? > > > > Otis > > > > > > _______________________________________________ > > cisco-nsp mailing list [email protected] > <mailto:[email protected]> > > <mailto:[email protected] > <mailto:[email protected]>> > > https://puck.nether.net/mailman/listinfo/cisco-nsp > <https://puck.nether.net/mailman/listinfo/cisco-nsp> > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
