if this is a bridged 1483 circuit (the newer DSL installations seem to be doing this vs PPPoA), then the config will need to be modified. you shouldn't be using a dialer interface. you will want to configure the interface for RBE (route bridge encap) as described below. and place the "ip address negotiated" on the ATM subint.
On Tue, 2 Oct 2007, Majdi S. Abbas wrote: > On Tue, Oct 02, 2007 at 01:58:51PM -0400, Adam Greene wrote: >> I'm trying to configure a DSL line on a Cisco 1841 (C1841-IPBASE-M), Version >> 12.4(1c). >> >> The atm interface is plugged into a DSL line, it shows up/up, I have packets >> going out, but none coming back in. >> >> Do I have to do something in particular to initiate the connection? Are >> there obvious errors with the config? Perhaps I need to contact the ISP. > > Try placing the following on the VC: > > atm route-bridge ip > > This should get it to actually recognize those RFC1483 bridged > frames and do the right thing with them. > > --msa > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
