Thanks Tom, The Amino STB is using the standard dot1.q config and when connected to an HP switch using the same trunking its ok. its now with the cisco that we are getting problems. here's the cisco config
interface FastEthernet0/14 switchport trunk encapsulation dot1q switchport trunk native vlan 100 switchport mode trunk switchport nonegotiate end There are two VLANs used in the network VLAN 1 and VLAN 100. what we are looking at is the VLAN 100 On Jan 4, 2008 4:26 PM, Tom Storey <[EMAIL PROTECTED]> wrote: > > On 04/01/2008, at 6:38 PM, Dracul wrote: > > > Hi all, > > > > Has anyone tried to integrate a non-cisco product using the standard > > dot1.qinto a cisco VLAN config? > > I am trying to integrate an AMINO STB (used for iptv) to a cisco > > dot1.qtrunk. any thoughts on this? > > > > regards, > > chris > > Im sure theres at least one person that has connected a non Cisco > device to a Cisco switch and trunked VLANs between the two, the > networking world is a big place after all. ;-) > > dot1q is a standard, an open standard at that, so compatability > *should* be more than guaranteed, unless someone doesnt conform to > said standard. > > If you cant get it working, its likely configuration related. Can you > show us what your configuration looks like, and perhaps we can point > something out that doesnt look right, or advise you where youve gone > wrong. > -- === Support www.gawadkalinga.org _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
