Hi Tom, You're correct. The other VLAN1 is used for internet
On Jan 4, 2008 5:09 PM, Tom Storey <[EMAIL PROTECTED]> wrote: > > On 04/01/2008, at 8:02 PM, Simon Lockhart wrote: > > > On Fri Jan 04, 2008 at 04:40:11PM +0800, Dracul wrote: > >> interface FastEthernet0/14 > >> switchport trunk encapsulation dot1q > >> switchport trunk native vlan 100 > >> switchport mode trunk > >> switchport nonegotiate > >> end > >> > >> There are two VLANs used in the network VLAN 1 and VLAN 100. what > >> we are > >> looking at is the VLAN 100 > > > > So you're trying to put the Amino STB in VLAN 100? Try this instead: > > > > interface FastEthernet0/14 > > switchport mode access > > switchport access vlan 100 > > spanning-tree portfast > > > > At the moment you've got it configured as a trunk port, with non- > > tagged frames > > being put in vlan 100. Whilst this shouldn't cause a problem, you > > can simplify > > it by configuring it as an access port instead. > > > > Simon > > I was about to ask if he could get away with running it as an access > port, but he spcifically mentioned trunking, so I was of the > impression that he needed both VLANs trunked to the box. > > Otherwise yes, if he needs it *only* in VLAN 100, setting it up as a > trunk port will do. But my guess is theres another reason that a > second VLAN is neccessary, e.g. Internet access which is provided via > a seperate VLAN. > -- === Support www.gawadkalinga.org _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
