So this is a layer 2 switching vs layer 3 switching performance issue. Are you running any policies or QOS on either switch? ACLs or anything other than a vanilla routing/switching setup? ________________________________________ From: Mark Kent [EMAIL PROTECTED] Sent: Monday, January 21, 2008 11:12 PM To: Mike Louis Cc: [email protected] Subject: Re: [c-nsp] cisco 3560 layer3 performance
>> Are both models the WS-C3560G-48TS-S version? yes, identical boxes. >> The first device you mentioned, is it running layer 2 only, into >> the L2 access switchport and then out to the L2 trunk? Yes. The default gateway for the server hanging off the first switch, which is layer2 only, is on a vlan on the second switch, which has that vlan plus a "no switchport ; ip address ..." port with it's default route on the other side of that circuit. Thanks, -mark Note: This message and any attachments is intended solely for the use of the individual or entity to which it is addressed and may contain information that is non-public, proprietary, legally privileged, confidential, and/or exempt from disclosure. If you are not the intended recipient, you are hereby notified that any use, dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the original sender immediately by telephone or return email and destroy or delete this message along with any attachments immediately. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
