Take a look at what the SDM says, with "show sdm prefer". If you're running a "vlan only" template, all L3-traffic is process switched. It that case you should change it to "default" or whatever suits your needs.
Regards, Peter On Mon, 2008-01-21 at 19:31 -0800, Mark Kent wrote: > Hello, > > I've got a cisco 3560 (WS-C3560G-48TS-S) pulling in > (80Mbs, 6500pps) on one switch port, and sending it > out a trunk... cpu load is 5%. > > Another cisco 3560, pulling in that same traffic on a trunk and > sending it out a layer3 point-to-point gigE is running at 70 to 80% > (cpu hog is "IP Input"). > > In fact, the cpu load is roughly the same as the Mbs load. 50Mbs = 50%. > > Now, I know it's a small switch in the cisco line. > But wouldn't we expect it to do a fair bit better than this? > It looks like it will crap out at 100Mbs of layer3 traffic. > > Thanks, > -mark > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
