If I run SXH on a 6500 platform with Sup720 can I also do MUX-UNI, or is 7600 required?
Bill Murphy Senior Network Analyst University of Texas Health Science Center - Houston -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Christian Bering Sent: Tuesday, April 08, 2008 9:07 AM To: Alex A. Pavlenko Cc: [email protected] Subject: Re: [c-nsp] 7600 SVI and subinterface combination >is it possible to combine both SVI(for ip routing) and >a subinterface(for EoMPLS) upon common >interface configured as a trunk on 67xx LAN card? Look up "mux-uni". <http://www.cisco.com/en/US/docs/routers/7600/ios/12.2SR/configuration/g uide/pfc3mpls.html#wp1406020> >In other words is following configuration ok? >interface GigabitEthernet1/1 > switchport > switchport trunk encapsulation dot1q > switchport mode trunk > switchport trunk allowed vlan 10,20 >interface GigabitEthernet1/1.20 > encapsulation dot1Q 20 > xconnect 1.2.3.4 1 encapsulation mpls You must use a seperate subinterface "vlan" than you are allowing across the trunk port. -- Regards Christian Bering IP engineer, nianet a/s Phone: (+45) 7020 8730 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
