Is it possible you're trying to boot an IOS version that doesn't support that chassis? I'm sure there is a minimum version for a 7604, and I'm sure it's more recent than the minimum for the 6500 it came out of.
Chuck -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Gregoire Huet Sent: Thursday, September 04, 2008 11:18 AM To: [email protected] Subject: [c-nsp] Moving Sup720 from cat6k to 7600 Hello I would like to boot a Sup720-3BXL in a 7604 chassis, but it won't. The sup was previously used in a cat6k chassis (as announced by the bootstrap), and even with a CompactFlash formatted on a running 7604/720-3BXL, the blade does not boot. The compact flash is readable and a 'dir' shows the image, but booting on it crashes after a while (there is just the ATA line displayed), and about 30 seconds after, it's returning to rommon with a weird message (that i can possibly report here if needed). Is there a known trick to 'convert' the blade from cat6k to 76xx ? Thanks a lot for any help Best regards, Gregoire Huet _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
