Definitely planning on having the cable guys extend our dmarc with pre-made cables.
How do you know if the DS3 signal is too hot? Thanks, Jeff -----Original Message----- From: Jay Nakamura [mailto:[email protected]] Sent: Friday, September 24, 2010 2:41 PM To: Jeff Wojciechowski Cc: [email protected] Subject: Re: [c-nsp] DS3 Nubie If you don't make DS3 cable often, I will recommend have a vendor make one for you. You may also want to buy or be ready to buy couple attenuators. At one location, the Telco equipment was sending out signal that was too hot for the DS3 interface and I had to attenuate it quite a bit. Telco would not lower the output for us. This electronic mail (including any attachments) may contain information that is privileged, confidential, or otherwise protected from disclosure to anyone other than its intended recipient(s). Any dissemination or use of this electronic mail or its contents (including any attachments) by persons other than the intended recipient(s) is strictly prohibited. If you have received this message in error, please delete the original message in its entirety (including any attachments) and notify us immediately by reply email so that we may correct our internal records. Midland Paper Company accepts no responsibility for any loss or damage from use of this electronic mail, including any damage resulting from a computer virus. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
