Typically you want to ensure that you can do scrambling with what ever card you use. Typical setup is a card with a built in CSU/DSU and enable kentrox scrambling...
Aaron On Fri, Sep 24, 2010 at 16:33, Jeff Kell <[email protected]> wrote: > On 9/24/2010 4:07 PM, Jay Nakamura wrote: > > Unless you have fancy DS3 test set, only way to find out is start > > using it. We saw bunch of errors but telco swore up and down that > > line was clear. This list clued me into possible hot circuit. Stuck > > a attenuator in the Rx side and error disappeared. > > Our old DS3 came with the coax-to-RJ45 balun adapters. Rather than > attenuate, we stuck > a long Cat5 jumper in the middle, worked just as well. This on a 7200VXR. > > Jeff > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
