The MPLS TE signaling usually uses the RSVP, but in the global configuration i didn't see any RSVP configuration, why? Is the the default configuraion?
Many thanks. Hu Xu 在 2012年2月20日 下午9:03，Oliver Boehmer (oboehmer) <[email protected]>写道： > ok.. you can also leave out the “autoroute-announce” for the beginning, > then the tunnel won’t take any traffic and you will be able to check if > everything is set up correctly (i.e. the primary/mesh tunnels are being > built and the backups are being installed), without any impact to the live > traffic..**** > > ** ** > > oli**** > > ** ** > > *From:* 许虎 [mailto:[email protected]] > *Sent:* 20 February 2012 14:00 > *To:* Oliver Boehmer (oboehmer) > *Subject:* Re: [c-nsp] MPLS TE conver from IOS to IOS-XR**** > > ** ** > > Thanks, oil, i will try in the live network tomorrow.**** > > 在 2012年2月20日 下午6:16，Oliver Boehmer (oboehmer) <[email protected]>写道：**** > > Hi,**** > > > > > Since now I can make sure the "Group" command in IOS-XR is the same to > the > > "Auto-Template" in IOS, but my problem is that in the IOS > "Auto-Template" I > > can use the below command : > > > > interface Auto-Template1 > > mpls mtu 17916 > > tunnel mpls traffic-eng autoroute announce > > tunnel mpls traffic-eng path-option 1 dynamic > > > > but in the Group, we just have the below command: > > > > XXXX(config-mpls-te)#auto-tunnel mesh > > XXXX(config-te-auto-mesh)#group 1 ? > > attribute-set Attribute-set name of type auto-mesh > > destination-list Destination-list (prefix-list) name > > disable Disable the mesh group > > <cr> > > > > So I am again wondering the group is not the same compared to the Auto- > > Template.**** > > you need to configure autoroute-announce and attribute-set, which you in > turn reference in the group.. look at the "autoroute announce" in the > config I sent. > As far as I know, path-option is always dynamic for auto-tunnel mesh in > XR, so no need to configure this. > > oli**** > > ** ** > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
