interface BVI101 description cust-bgp-1 vlan 101 ipv4 address x.x.x.x 255.255.255.252 ipv4 access-group cust-bgp-1-out-acl egress
This is gained support in 4.2.0 I think. --chip On Thu, Jul 19, 2012 at 12:39 PM, Aaron <[email protected]> wrote: > Are acl's supported on BVI's ? > > I have a phy int g0/0/0/1 with a flow point (sub int) g0/0/0/1.10 > l2transport config'd and put into l2vpn bg:bd with a routed int inside that > bg:bd as bvi 10 > > > > I would think that the appropriate location to place an ipv4 access-list > would be on the L3 interface , that being the bvi. But I don't see the > command "ipv4 access-list" under the bvi. > > > > What am I missing here ? > > > > Aaron > > > > > > > > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ -- Just my $.02, your mileage may vary, batteries not included, etc.... _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
