Many things missing....
http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/interfaces/configuration/guide/hc42irb.html#wp1011723
The following areas are /not/ supported on the BVI:
–Access Control Lists (ACLs). However, Layer 2 ACLs can be configured on each Layer 2 port
of the bridge domain.
–IP fast reroute (FRR)
–NetFlow
–MoFRR
–MPLS label switching
–mVPNv4
–Quality of Service (QoS)
–Traffic mirroring
–Unnumbered interface for BVI
–Video monitoring (Vidmon)
--
Tassos
chip wrote on 19/7/2012 19:45:
interface BVI101
description cust-bgp-1 vlan 101
ipv4 address x.x.x.x 255.255.255.252
ipv4 access-group cust-bgp-1-out-acl egress
This is gained support in 4.2.0 I think.
--chip
On Thu, Jul 19, 2012 at 12:39 PM, Aaron <[email protected]> wrote:
Are acl's supported on BVI's ?
I have a phy int g0/0/0/1 with a flow point (sub int) g0/0/0/1.10
l2transport config'd and put into l2vpn bg:bd with a routed int inside that
bg:bd as bvi 10
I would think that the appropriate location to place an ipv4 access-list
would be on the L3 interface , that being the bvi. But I don't see the
command "ipv4 access-list" under the bvi.
What am I missing here ?
Aaron
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
