On Fri, 21 Sep 2012, Joseph Mays wrote:
interface FastEthernet0/22
description Trunk to sw2.dist.win.net
duplex full
speed 100
switchport access vlan 22
switchport trunk allowed vlan 1,201-224,1002-1005
switchport mode trunk
no cdp enable
The client on the remote switch, vlan 202, does not work through the new
switch. On sw2 the uplink port is port 5, the client is on port 6.
I don't know what might be causing this, unless something about the vlan
database is not created by cutting and pasting the config from the
2900XL to the 2960.
Did you create the vlans on the 2960? The vlans allowed on that port
(other than 1) aren't going to work until/unless the 2960 knows those
vlans exist. This info was probably hidden in the vlan database (not
present in the running/startup config) on the 2900.
----------------------------------------------------------------------
Jon Lewis, MCP :) | I route
Senior Network Engineer | therefore you are
Atlantic Net |
_________ http://www.lewis.org/~jlewis/pgp for PGP public key_________
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
