On 04/20/2015 05:28 PM, Andrew Miehs wrote:
Have you tried swapping the two interfaces between the chassis?
Nope, because it happens on several interfaces in "router A", spread across two line cards. Interfaces are in routed mode with several subinterfaces configured; there's a clear pattern in the subinterfaces that are fully hardware switched and subinterfaces that are partially software switched. There's at least one subinterface where I can manipulate the config; when adding PBR it goes to fully hardware switched, when removing PBR it goed to partially in software. And exactly the same configs always work fully hardware switched in router B.
My conclusion from that, is that swapping interfaces (which I interpret in this case as swapping the transceivers) can't possibly make a difference.
Thanks for your thought though. Regards, Jeroen van Ingen ICT Service Centre University of Twente, P.O.Box 217, 7500 AE Enschede, The Netherlands _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
