On 04/21/2015 12:21 AM, Andrew Miehs wrote:
I actually meant line cards. So if I understand correctly both boxes
have at least 2x6904. How many of your cards have the low revision
number? 1 in the box or 2 ? Does moving these cards change which box
is software switching?
Router A:
mod 1 WS-X6824-SFP hw 1.0 fw 12.2(18r)S1, DFC4-A hw 1.0
mod 2 WS-X6904-40G hw 1.0 fw 12.2(50r)SYL, DFC4-E hw 1.2
mod 3 WS-X6904-40G hw 1.0 fw 12.2(50r)SYL, DFC4-E hw 1.2
mod 5 VS-SUP2T-10G hw 1.6 fw 12.2(50r)SYS, PFC4 hw 1.1 & MSFC5 hw 1.6
Router B:
mod 1 WS-X6824-SFP hw 1.0 fw 12.2(18r)S1, DFC4-A hw 1.0
mod 2 WS-X6904-40G hw 1.0 fw 12.2(50r)SYL, DFC4-E hw 1.2
mod 3 WS-X6904-40G hw 1.0 fw 12.2(50r)SYL, DFC4-E hw 1.2
mod 5 VS-SUP2T-10G hw 1.4 fw 12.2(50r)SYS, PFC4 hw 2.0 & MSFC5 hw 1.5
... so the only difference is in Sup/PFC/MSFC; the line card revisions
are the same in both boxes.
We did a full power down on Router A this morning, reseated all modules
(SUP and LCs), but then after power on it got back into exactly the same
state: software switching on exactly the same subinterfaces as before
the reboot.
Regards,
Jeroen van Ingen
ICT Service Centre
University of Twente, P.O.Box 217, 7500 AE Enschede, The Netherlands
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
