I actually meant line cards. So if I understand correctly both boxes have at least 2x6904. How many of your cards have the low revision number? 1 in the box or 2 ? Does moving these cards change which box is software switching? Sent from a mobile device
> On 21 Apr 2015, at 01:40, Jeroen van Ingen <[email protected]> wrote: > >> On 04/20/2015 05:28 PM, Andrew Miehs wrote: >> Have you tried swapping the two interfaces between the chassis? > > Nope, because it happens on several interfaces in "router A", spread across > two line cards. Interfaces are in routed mode with several subinterfaces > configured; there's a clear pattern in the subinterfaces that are fully > hardware switched and subinterfaces that are partially software switched. > There's at least one subinterface where I can manipulate the config; when > adding PBR it goes to fully hardware switched, when removing PBR it goed to > partially in software. And exactly the same configs always work fully > hardware switched in router B. > > My conclusion from that, is that swapping interfaces (which I interpret in > this case as swapping the transceivers) can't possibly make a difference. > > Thanks for your thought though. > > Regards, > > Jeroen van Ingen > ICT Service Centre > University of Twente, P.O.Box 217, 7500 AE Enschede, The Netherlands > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
