REP frames are sent untagged to 0100.0ccc.ccce. Try adding encapsulation untagged to your service instances.
On Thu, Jan 11, 2018 at 2:40 AM, Fernando Cardoso <[email protected]> wrote: > Hi, > > i'm trying to pass REP through a MPLS network. the two PE are me3600. > The configuration: > > Me 3600 PE1: > interface GigabitEthernet0/xx > switchport trunk allowed vlan none > switchport mode trunk > mtu 9216 > service instance 100 ethernet > encapsulation dot1q 1-4094 > rewrite ingress tag push dot1q 100 symmetric > l2protocol forward > service-policy input ratelimit_200Mb > xconnect xxx.xxx.xxx.xxx 100 encapsulation mpls > > Me 3600 PE2: > interface GigabitEthernet0/yy > switchport trunk allowed vlan none > switchport mode trunk > mtu 9216 > service instance 100 ethernet > encapsulation dot1q 1-4094 > rewrite ingress tag push dot1q 100 symmetric > l2protocol forward > service-policy input ratelimit_200Mb > xconnect yyy.yyy.yyy.yyy 100 encapsulation mpls > > > > I have no success the REP between CE´s not working, I tried with > "l2protocol tunnel" but the problem persists... > > > > The ios image used is "me360x-universal-mz.154-3.S2.bin" > > > > Can see anything about this online, does anyone have this issue? > > > Best Regards > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
