You can try restarting TFTP. Also see if you can download the .loads file with a TFTP Client.
On Fri, Jun 16, 2017 at 2:13 AM, naresh rathore <[email protected]> wrote: > hi, > > > > I am facing two issues with DX80. > > > > > 1. First, video call is not successful with DX80. when i check self > view (while not on call).there is nothing. so i think there can be issue > with the camera. video call is enabled on Device > Phone and between video > and phone device pool, the codec is G711, maximum session bit rate for > video calls: 384kbps, maximum session bit rate for immersive video calls: > 1024kbps > > > > 2. Second, is the upgrade (may be upgrade will resolve camera > issue) . Currently DX80 is on android firmware and the required firmware is > also android. I use ftp/sftp to upload the file on both cucm, on one cucm > tftp service is active while on another cucm (sub), tftp is not active but > i uploaded file on both of them and can see the .load file on tftp file > management. but see the following status after upgrade (upgrade failed). > > > *Registration:* Registered with Cisco Unified Communications Manager > CUCM02 > *IPv4 Address:* x.x.x.x <http://10.163.167.14/> > *Active Load ID:* sipdx80.10-2-2-23 > *Inactive Load ID:* INVALID > *Download Status:* Failed > *Requested Load ID:* sipdx80.10-2-4-99 > *Download Server:* 10.163.72.100 > Inactive Load Failure Reason File Not Found > Any suggestions. > > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
