It just depends on what the DX80 is pointed at. If it's set to use the pub as TFTP server 1 then you're fine.
On Fri, Jun 16, 2017 at 3:12 AM, naresh rathore <[email protected]> wrote: > is it necessary to active tftp service on cucm-sub? or > > > > when i point it to cucmpub. i succesfuly downloaded the file using tftp. > but when i pointed it to cucmsub, the file was 0byte, not successfully > downloaded (because tftp is not enabled on cucmsub. > > > > Regards > > > > Naray > > > ------------------------------ > *From:* [email protected] <[email protected]> on behalf of Brian Meade < > [email protected]> > *Sent:* Friday, June 16, 2017 11:38 AM > *To:* naresh rathore > *Cc:* [email protected] > *Subject:* Re: [cisco-voip] DX80 issues. > > You can try restarting TFTP. Also see if you can download the .loads file > with a TFTP Client. > > On Fri, Jun 16, 2017 at 2:13 AM, naresh rathore <[email protected]> > wrote: > >> hi, >> >> >> >> I am facing two issues with DX80. >> >> >> >> >> 1. First, video call is not successful with DX80. when i check self >> view (while not on call).there is nothing. so i think there can be issue >> with the camera. video call is enabled on Device > Phone and between video >> and phone device pool, the codec is G711, maximum session bit rate for >> video calls: 384kbps, maximum session bit rate for immersive video calls: >> 1024kbps >> >> >> >> 2. Second, is the upgrade (may be upgrade will resolve camera >> issue) . Currently DX80 is on android firmware and the required firmware is >> also android. I use ftp/sftp to upload the file on both cucm, on one cucm >> tftp service is active while on another cucm (sub), tftp is not active but >> i uploaded file on both of them and can see the .load file on tftp file >> management. but see the following status after upgrade (upgrade failed). >> >> >> *Registration:* Registered with Cisco Unified Communications Manager >> CUCM02 >> *IPv4 Address:* x.x.x.x <http://10.163.167.14/> >> *Active Load ID:* sipdx80.10-2-2-23 >> *Inactive Load ID:* INVALID >> *Download Status:* Failed >> *Requested Load ID:* sipdx80.10-2-4-99 >> *Download Server:* 10.163.72.100 >> Inactive Load Failure Reason File Not Found >> Any suggestions. >> >> >> _______________________________________________ >> cisco-voip mailing list >> [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-voip >> >> >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
