Option 150 is all you need to worry about for TFTP downloads. On Fri, Jun 16, 2017 at 3:38 AM, naresh rathore <[email protected]> wrote:
> i will check option 150 later, but cucmsub is preferred in cucm group > (devicepool) > > > ------------------------------ > *From:* [email protected] <[email protected]> on behalf of Brian Meade < > [email protected]> > *Sent:* Friday, June 16, 2017 12:19 PM > > *To:* naresh rathore > *Cc:* [email protected] > *Subject:* Re: [cisco-voip] DX80 issues. > > It just depends on what the DX80 is pointed at. If it's set to use the > pub as TFTP server 1 then you're fine. > > On Fri, Jun 16, 2017 at 3:12 AM, naresh rathore <[email protected]> > wrote: > >> is it necessary to active tftp service on cucm-sub? or >> >> >> >> when i point it to cucmpub. i succesfuly downloaded the file using tftp. >> but when i pointed it to cucmsub, the file was 0byte, not successfully >> downloaded (because tftp is not enabled on cucmsub. >> >> >> >> Regards >> >> >> >> Naray >> >> >> ------------------------------ >> *From:* [email protected] <[email protected]> on behalf of Brian Meade >> <[email protected]> >> *Sent:* Friday, June 16, 2017 11:38 AM >> *To:* naresh rathore >> *Cc:* [email protected] >> *Subject:* Re: [cisco-voip] DX80 issues. >> >> You can try restarting TFTP. Also see if you can download the .loads >> file with a TFTP Client. >> >> On Fri, Jun 16, 2017 at 2:13 AM, naresh rathore <[email protected]> >> wrote: >> >>> hi, >>> >>> >>> >>> I am facing two issues with DX80. >>> >>> >>> >>> >>> 1. First, video call is not successful with DX80. when i check self >>> view (while not on call).there is nothing. so i think there can be issue >>> with the camera. video call is enabled on Device > Phone and between >>> video >>> and phone device pool, the codec is G711, maximum session bit rate for >>> video calls: 384kbps, maximum session bit rate for immersive video calls: >>> 1024kbps >>> >>> >>> >>> 2. Second, is the upgrade (may be upgrade will resolve camera >>> issue) . Currently DX80 is on android firmware and the required firmware is >>> also android. I use ftp/sftp to upload the file on both cucm, on one cucm >>> tftp service is active while on another cucm (sub), tftp is not active but >>> i uploaded file on both of them and can see the .load file on tftp file >>> management. but see the following status after upgrade (upgrade failed). >>> >>> >>> *Registration:* Registered with Cisco Unified Communications Manager >>> CUCM02 >>> *IPv4 Address:* x.x.x.x <http://10.163.167.14/> >>> *Active Load ID:* sipdx80.10-2-2-23 >>> *Inactive Load ID:* INVALID >>> *Download Status:* Failed >>> *Requested Load ID:* sipdx80.10-2-4-99 >>> *Download Server:* 10.163.72.100 >>> Inactive Load Failure Reason File Not Found >>> Any suggestions. >>> >>> >>> _______________________________________________ >>> cisco-voip mailing list >>> [email protected] >>> https://puck.nether.net/mailman/listinfo/cisco-voip >>> >>> >> >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
