i will check option 150 later, but cucmsub is preferred in cucm group (devicepool)
________________________________ From: [email protected] <[email protected]> on behalf of Brian Meade <[email protected]> Sent: Friday, June 16, 2017 12:19 PM To: naresh rathore Cc: [email protected] Subject: Re: [cisco-voip] DX80 issues. It just depends on what the DX80 is pointed at. If it's set to use the pub as TFTP server 1 then you're fine. On Fri, Jun 16, 2017 at 3:12 AM, naresh rathore <[email protected]<mailto:[email protected]>> wrote: is it necessary to active tftp service on cucm-sub? or when i point it to cucmpub. i succesfuly downloaded the file using tftp. but when i pointed it to cucmsub, the file was 0byte, not successfully downloaded (because tftp is not enabled on cucmsub. Regards Naray ________________________________ From: [email protected]<mailto:[email protected]> <[email protected]<mailto:[email protected]>> on behalf of Brian Meade <[email protected]<mailto:[email protected]>> Sent: Friday, June 16, 2017 11:38 AM To: naresh rathore Cc: [email protected]<mailto:[email protected]> Subject: Re: [cisco-voip] DX80 issues. You can try restarting TFTP. Also see if you can download the .loads file with a TFTP Client. On Fri, Jun 16, 2017 at 2:13 AM, naresh rathore <[email protected]<mailto:[email protected]>> wrote: hi, I am facing two issues with DX80. 1. First, video call is not successful with DX80. when i check self view (while not on call).there is nothing. so i think there can be issue with the camera. video call is enabled on Device > Phone and between video and phone device pool, the codec is G711, maximum session bit rate for video calls: 384kbps, maximum session bit rate for immersive video calls: 1024kbps 2. Second, is the upgrade (may be upgrade will resolve camera issue) . Currently DX80 is on android firmware and the required firmware is also android. I use ftp/sftp to upload the file on both cucm, on one cucm tftp service is active while on another cucm (sub), tftp is not active but i uploaded file on both of them and can see the .load file on tftp file management. but see the following status after upgrade (upgrade failed). Registration: Registered with Cisco Unified Communications Manager CUCM02 IPv4 Address: x.x.x.x<http://10.163.167.14/> Active Load ID: sipdx80.10-2-2-23 Inactive Load ID: INVALID Download Status: Failed Requested Load ID: sipdx80.10-2-4-99 Download Server: 10.163.72.100 Inactive Load Failure Reason File Not Found Any suggestions. _______________________________________________ cisco-voip mailing list [email protected]<mailto:[email protected]> https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
