Yes, when I say frame relay back to back or point to point I mean that you can have one router's serial directly connected to another's and run frame relay sub interfaces on each, with no frame switch. Unfortunately I don't have the link that shows how to do this and I never memorized it, I am sure someone on the list does though.
-----Original Message----- From: Richard Orabone [mailto:[EMAIL PROTECTED] Sent: Friday, September 05, 2003 9:58 AM To: [EMAIL PROTECTED] Subject: RE: Stuck on Subinterfaces - HELP! [7:74854] Thanks for the detailed description Guy. That helps quite a bit. I think maybe the Book just assumes that when you see IP's on Serial Subinterfaces, you will understand that Frame Relay Encapsulation was set up on them ahead of time and just skips ahead to the OSPF, IS-IS configurations. So I skipped ahead yesterday to the Remote Access Book and learned all about Frame Relay Networks. Another question then: When you say "Frame Relay running Back to Back", does this mean that I could set up Frame Relay Point-to-Point Encapsulation between Serial Subinterfaces on 2 Routers directly without a Frame Relay Switch or Network in the middle? If so this may be what is shown in the Labs in the Book. Thanks Again. Rich. **Please support GroupStudy by purchasing from the GroupStudy Store: http://shop.groupstudy.com FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=74908&t=74854 -------------------------------------------------- **Please support GroupStudy by purchasing from the GroupStudy Store: http://shop.groupstudy.com FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
