I'd be careful with any abrasive products. They'll eventually wear off the gelcoat. The only abrasive I would even suggest for gelcoat is AquaBuff 2000. It's a polishing compound. It will smooth and polish gelcoat but is still lightly abrasive.
I used to use SoftScrub with bleach but decided that was too abrasive. Now I use Scrubbing Bubbles Foaming Bleach. Does an awesome job removing mildew. Not sure how it would work on rust stains. Dennis C. Touche' 35-1 #83 Mandeville, LA On Tue, Aug 18, 2015 at 2:35 PM, Stevan Plavsa via CnC-List < cnc-list@cnc-list.com> wrote: > Barkeeper's Friend. Available at Canadian Tire. I swear by this stuff. > (it's acid based, forget which acid, but I've been using it on my gelcoat > for years on two boats). > > Steve > Suhana, C&C 32 > Toronto > > On Tue, Aug 18, 2015 at 3:01 PM, svpegasu...@gmail.com < > cnc-list@cnc-list.com> wrote: > >> I think hou are on the right track. You will get a better job. I can do >> welding but when my stern pulpit need work I took it in. They did a much >> better job than I could have done. >> >> >> Doug Mountjoy >> >> svPegasus >> >> LF38 >> >> just west of Ballard, WA. >> >> >> >> _______________________________________________ >> >> Email address: >> CnC-List@cnc-list.com >> To change your list preferences, including unsubscribing -- go to the >> bottom of page at: >> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >> >> >> > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com