Something I haven't exactly found in the FAQs is which jumpers need to be strapped for
proper operations, or maybe I'm not reading the right ones. I have a few HP OEMed
drives that are giving me fits. They work fine in an external drive case, but when I
put them in the machine, LIDO and HD Setup both report SCSI termination errors.
Here's the strapping:
+--+
TP to Bus --> |..| <-- TP from Bus
TP from Drive |..|
Reserved |..|
Parity Disable |..|
Write Protect |..|
Motor Start Enabled |..|
Delay MTR Start |..|
Term Enable |..|
+--+
Now, I've set just about every possible combination (I kept track) of strapping the TP
to Bus/TP from Bus and the TE jumpers and cannot get them to work. As I stated above,
I was able to use/format the drive in an external chassis, but no joy when I put it in
any machine.
Help! (and thanks!)
Jack
--
Compact Macs is sponsored by <http://lowendmac.com/>.
Support Low End Mac <http://lowendmac.com/lists/support.html>
Compact Macs list info: <http://lowendmac.com/lists/compact.shtml>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:[EMAIL PROTECTED]>
To unsubscribe, email: <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/>
---------------------------------------------------------------
>The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------
