I suspect the video card is going bad, or sometimes it get hot...when this happens, try on your own risk and dont get your hand burnt, try checking if the video card is hot...if it has a cooler or fan, is it working properly? Try updating or reinstalling your video card drivers.
On Mar 23, 11:03 pm, Miran <[email protected]> wrote: > Please, do not be offended, i know my question was very basic, however, you > never know. Sometimes, the most basic solutions, are the best, and they do > work. Now, if you never get any beep after a RAM upgarde or any change, > perhaps somethin is wrong with your bios. Have you tried to install a newer > version an see what hapens? I think that whatever you do, whenever you > change the hardware configuration of your computer, put a new slot in or > take one our, your bios, should see the difference and (beep), aknowledge > the change. > > > > On Mon, Mar 23, 2009 at 9:57 PM, <[email protected]> wrote: > > The PC is running at a normal tempurature and the 2 sticks of ram I bought > > at the same time. > > > ----- Original Message ----- > > From: "Phantom" <[email protected]> > > To: "Computer Tech Support" <[email protected]> > > Sent: Sunday, March 22, 2009 5:55:23 AM GMT -05:00 US/Canada Eastern > > Subject: [6422] Re: Mystery BSOD > > > Have you checked the temperature? Are you using the same RAM in all > > 4 slots? > > > On Mar 17, 4:18 pm, [email protected] wrote: > > > I originally sent an email about this Blue Screen of Death problem back > > in Oct. I received great help from BigMatt and RemyMaza and Tom Wade. > > > > The blue screen says the following: > > > > A problem has been detected and windows has been shut down to prevent > > > damage to your computer. If this the first time you've seen this Stop > > error screen, restart your > > > computer. > > > > If this screen appears again, follow these steps: > > > > Run a system diagnostic utility supplied by your hardware manufacturer. > > In > > > particular, run a memory check, and check for faulty or mismatched > > memory. > > > Try changing video adapters. Disable or remove any newly installed > > hardware and > > > drivers. Disable or remove any newly installed software. > > > > If you need to use SafeMode to remove or disable components, restart your > > computer, press F8 to > > > select Advanced Startup Options, then select SafeMode. > > > > Technical Information: *** STOP: 0X0000007F (0X0000009D, 0X00000000, > > OX00000000, 0X00000000) > > > Contact your system administrator or technical support group for further > > assistance. > > > > I have an HP Media Center Photosmart m1095c Desktop that was bought > > 8-31-04. > > > > It has an Intel P4 540 3.2 Ghz with hyperthreading; 800 Mhz frontside > > > > Asus PTGD1-LA Intel 915P chipset > > > > I have upgraded the RAM to two 512MB sticks from HP: PC 3200 184 pin DDR > > > > Video card is a Radeon X600 Pro AGP: 256 MB DDR > > > > Back in Oct. BigMatt suggested I take out one RAM stick at a time and run > > the PC with a lot of graphics going. I did just that and ran through all > > the different combinations of RAM sticks in all 4 RAM slots on the mb. It > > mysteriously seemed to fix itself. It's been running great since then. > > > > Recently I renewed/upgraded my Norton Antivirus to what they call Norton > > 360. Immediately I started getting the BSOD again. Sometimes it appears in > > minutes, sometimes it's hours. > > > > I have never gotten any RAM beeps on start up. Again I ran through all > > the combinations of RAM sticks in all 4 RAM slots and this time it always > > goes to the blue screen. I have used the onboard HP diagnostic tool and ran > > checks on the RAM and video card. When I run the check, a dignostic > > progress screen pops up saying the check will take several minutes and > > another smaller Windows IE window pops up in top of that one that says: > > Exception in DisplayRunMap.runMap: with an OK box below it. I click OK, > > that box closes and the diagnostic tool box shows the progressive horizontal > > bar indicating the check in running. However, instead of taking several > > minutes, it takes only a few seconds. I'm not sure this check is really > > running a valid check. There are no error messages that pop up indicating > > any trouble with either the RAM or video card. > > > > I talked with a real nice guy, Raj Kiran in India with Norton tech > > support, but he wasn't any help. > > > > I really need HEEEELP in figuring this problem out. I'm confident > > someone in this forum has the tech saavy to come up with a solution. If you > > need any other info from me, let me know. > > > > ALSO, on occaision, I get something new that's random. The 19" HP flat > > screen monitor goes black and there's a small window in the middle of it > > that says: " Out Of Range Set Monitor To: 1280 X 1024 @ 60 Hz" At the > > bottom of this small window is row of monitor control buttons similar to > > what is on the monitor itself. When I try to operate the buttons on the > > monitor they do nothing. The only way I can get rid of this window is to do > > a hard shut down. > > > > Thank you, > > > > Mike Rosborough > > -- > --------------------------------------- > Miran O. > Phantom Design Labs > --------------------------------------- --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Computer Tech Support" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/computer-tech-support?hl=en -~----------~----~----~----~------~----~------~--~---
