Indeed, 3c589c is a PCMCIA 10Mbit combo ethernet card... I tried RC3 and during install it was NOT recognized... Perhaps I should try again with the final first, as soon as I can find a good ftp site (suggestions, btw?)...
Regards, Pieter -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Buchan Milne Sent: donderdag 26 september 2002 18:37 To: [EMAIL PROTECTED] Subject: Re: [Cooker] 3com 3c589c [pieter78] Todd Franklin wrote: > I'm using a 3com 3c905tx. Any 3com NIC should just plain work. No > extraneous configuration necesary. Are you perhaps using a static IP? > If so you may not have your IP and subnet mask set properly. If > you're using DHCP, make sure you're specifying it in the nic > configuration. > > todd > > J. Greenlees wrote: > >> Pieter Kubben wrote: >> >>> Hi, >>> >>> Does someone know if there are drivers available for the 3com 3c589c >>> NIC? >>> >>> Regards, >>> >>> Pieter >>> >>> >>> >> yup, I'm using same card on this machine. >> it should autodetect the card, it did for me. > But I think the 3c589C is a PCMCIA/Cardbus NIC? At least my 3c589D is. And that worked out the box with rc2. Buchan -- |----------------Registered Linux User #182071-----------------| Buchan Milne Mechanical Engineer, Network Manager Cellphone * Work +27 82 472 2231 * +27 21 8828820x121 Stellenbosch Automotive Engineering http://www.cae.co.za GPG Key http://ranger.dnsalias.com/bgmilne.asc 1024D/60D204A7 2919 E232 5610 A038 87B1 72D6 AC92 BA50 60D2 04A7
