https://qa.mandrakesoft.com/show_bug.cgi?id=1801
------- Additional Comments From [EMAIL PROTECTED] 2003-02-19 14:52 ------- One more note about this... The 60gb Maxtor is the only hard drive in the system. It is hooked up to the PDC20276 as master. The CDROM drives are hooked up on the standard IDE: Toshiba DVD-ROM is primary slave, LiteOn burner is secondary master. Only the Maxtor is hooked up on the PDC20276 and fails all detection as a device that can be used for filesystems. In v9.0, the installer would detect all of the drives and find the hard drive (even without loading a SCSI driver like ataraid), but then all of a sudden the CDROM drives would quit working. I tried moving drives around and jumpering everything to no avail... dunno if that provides any clues, but I've not been able to use Mandrake on this motherboard at all. Here's to hoping it gets solved for 9.1! :) ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: UNCONFIRMED creation_date: description: 9.1 RC1 installation fails on an Asus P4B533-E motherboard with the MBFasttrack133 controller. The installer detects that a SCSI interface is in the machine and asks for which module to load. I choose ataraid.o and the installer reports that the module was successfully loaded and the SCSI interface was found. Then it asks if there are any others. No matter what I choose at this point... If I say "No," it will report that there are no devices available to install filesystems. If I say "Yes," it naturally drops me back to the SCSI module selection screen. My hard drive is hooked up to this PDC20276 controller. My CDROMs are hooked up to standard IDE controller apart from the PDC20276. Since this problem existed in 9.0 (in a much much worse way) I was really looking forward to 9.1 solving this!
