https://qa.mandrakesoft.com/show_bug.cgi?id=1801
------- Additional Comments From [EMAIL PROTECTED] 2003-02-19 19:47 ------- Created an attachment (id=194) --> (https://qa.mandrakesoft.com/attachment.cgi?id=194&action=view) Bug report when failled to install rc1 on a PDC20276 ataraid controller I've tried to install mdk91 RC1 on a Gigabyte k7VAXP with ata/raid promise PDC20276 controller. Naturaly, it's failled detecting my hard disk, so i've tried to load module ataraid and here is the result of the experience. Notice that mdk9.0 works very well with the same configuration, but I'm not sure that it's really ataraid.o that I need, as for me, PDC20xx.o , which I found in mdk9 is more apropriated, but I must be wrong. in any case, I'm unable to install 9.1, because no Hard disk were detected. I hope that it will corrected ... if I can give any help, I'll do with my best. Simon ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: UNCONFIRMED creation_date: description: 9.1 RC1 installation fails on an Asus P4B533-E motherboard with the MBFasttrack133 controller. The installer detects that a SCSI interface is in the machine and asks for which module to load. I choose ataraid.o and the installer reports that the module was successfully loaded and the SCSI interface was found. Then it asks if there are any others. No matter what I choose at this point... If I say "No," it will report that there are no devices available to install filesystems. If I say "Yes," it naturally drops me back to the SCSI module selection screen. My hard drive is hooked up to this PDC20276 controller. My CDROMs are hooked up to standard IDE controller apart from the PDC20276. Since this problem existed in 9.0 (in a much much worse way) I was really looking forward to 9.1 solving this!
