2011/3/4 Fabrizio <[email protected]> > > Salve, > > Dominio di Routing con OSPF entro una singola Area. > Ho un Router ( R1 ) che collega un Router ( R2 ) attraverso una Wic di 1 GB > Ethernet e a sua volta altri Router ( Rx ) collegati con una WIC di una Fast > Ethernet 100 mb. > > Esempio: > > > ( R1 ) - - - 1GB - - - ( R2 ) - - - 100MB - - - ( R3 ) - - - 100 MB - - - ( > R4 ) - - - 1Gb - - - ( R5 ) > > Legenda (anche se è ovvia): > > - - - 100mb e 1Gb = Speed Link tra i Router > > Nel caso del Link R2 che collega R3, dovrei modificare il Reference Bandwidth > 10^8 , in quanto è maggiore di 100Mb. > Quindi : > > R1(config)#router ospf 1 > R1(config-router)#auto-cost reference-bandwidth 1000 > % OSPF: Reference bandwidth is changed. > Please ensure reference bandwidth is consistent across all routers. > R1(config-router)#^Z > > R2(config)#router ospf 1 > R2(config-router)#auto-cost reference-bandwidth 1000 > % OSPF: Reference bandwidth is changed. > Please ensure reference bandwidth is consistent across all routers. > R2(config-router)#^Z > > R4(config)#router ospf 1 > R4(config-router)#auto-cost reference-bandwidth 1000 > % OSPF: Reference bandwidth is changed. > Please ensure reference bandwidth is consistent across all routers. > R4(config-router)#^Z > > R5(config)#router ospf 1 > R5(config-router)#auto-cost reference-bandwidth 1000 > % OSPF: Reference bandwidth is changed. > Please ensure reference bandwidth is consistent across all routers. > R5(config-router)#^Z > > ho letto che se modifico il comando Reference Bandwidth , dovrò > automaticamente modificarlo in tutti i router entro lo stesso dominio di > routing quindi entro nella stessa singola area. > Ma se un outgoing interface di R2 - R3 - R4 hanno una velocità di 100mb, > perchè dovrei modificarlo? > > > _______________________________________ > Articoli CISCO: http://www.areanetworking.it/category/cisco > [email protected] > http://ml.areanetworking.it/mailman/listinfo/cug >
ciao Fabrizio, Semplicemente perché la metrica viene calcolata dividendo la reference bandwidth x la banda del singolo link. Altrimenti avresti metriche non coerenti tra i vari router, e teoricamente instabilità della rete. Poi, nel tuo caso, la cosa non conta più di tanto, visto che sono collegati tutti in linea (non ci sono anelli). Ivan _______________________________________ Articoli CISCO: http://www.areanetworking.it/category/cisco [email protected] http://ml.areanetworking.it/mailman/listinfo/cug
