On 02/10/2014 07:43, [email protected] wrote: > I'm trying to put the 2.0 base image on my Flame, but I think it's getting > stuck at the first "flashboot flash" command. It says "Partition table..." > but then says "<waiting for device>," and never gets past that. The screen > goes blank and the LED indicator light goes off, and it stays that way until > I kill the terminal and unplug the USB cable from the phone. Then the phone > turns back on after a few seconds. > > I have adb and fastboot installed and on my $PATH, and I'm doing sudo > ./flash.sh. I'm on Ubuntu 14.04 right now, but I tried earlier on Mac OSX and > it did the same thing. The device does show up when I type adb devices. It's > on version 1.3.0.0-prerelease.
Have you checked if your udev rules are setup correctly and if the phone
is visible in fastboot mode? A quick way to check it out is to reboot
the phone and keep both the power and volume down button pressed. You
should end up with a black screen and a purple "FASTBOOT" logo on it.
Now plug your device to your computer and run "fastboot devices" on the
command-line, you should see a single line of output like this:
3567d0f7 fastboot
If you don't get any output then check if you have the following rule in
/etc/udev/rules.d/51-android.rules
# Google
SUBSYSTEM=="usb", ATTRS{idVendor}=="18d1", MODE="0666"
If you don't add it, restart your machine and try again.
Gabriele
signature.asc
Description: OpenPGP digital signature
_______________________________________________ dev-b2g mailing list [email protected] https://lists.mozilla.org/listinfo/dev-b2g
