I believe the keys are installed properly in the card. When I dump the session, I can see the rate stuck at 6Mbps, again I see this for 802.11a channels and not for 802.11g channels.
--Fabrice On 11/21/2011 3:45 PM, Thomas Pedersen wrote: > Fabrice, > > On Mon, Nov 21, 2011 at 1:30 PM, Fabrice Deyber > <[email protected]> wrote: >> Quick update, >> I just found out that if I fix the rate with the following command: iw >> set mesh0 bitrates legacy-5 54, I get the expected performance. (17-18 >> Mbps on channel 48, still 1 hop test) >> For some reason it seems like the proper bitrate is no advertised in >> secured mode and the TX rate stays stuck at 6Mbps. >> It sounds like what Thomas was saying, ADDBA requests may be dropped by >> the peer in secured mode. Is there a patch available for this? > I was mistaken, a BA session is successfully created in secure mesh. > We should advertise the proper supported rates from authsae though. > > It is interesting throughput is so degraded for forwarded traffic with > hardware encryption. Theoretically, this should work fine since the > keys for any target STA are already installed in the card. > > Thomas > _______________________________________________ Devel mailing list [email protected] http://open80211s.com/mailman/listinfo/devel
