I loaded up a fresh image of pCP6 onto my spare 4B 1GB, then installed sbpd and LMS, and copied my sbpd configuration and calling script over. The buttons worked erratically - pressing one button would trigger several events. So then I tried a 'bare wires' test with a number of jumper wires and saw the same thing. In fact just touching the wires with my finger was enough to trigger several events - the symptoms on the pull-ups not being set. I tried 'gpio readall' which confirmed that none of the pins had the pull-ups set.
I tried updating wiringpi, and pCP confirmed that an update was available. After the update the buttons all work correctly on this 4B. Does this mean that sbpd is not installing the correct wiringpi, and is still using the one from before it was updated for the 4B? So then onto my main 4B 4GB. The erratic button behaviour is a bit different - button presses don't attempt to trigger multiple events, they often don't trigger anything at all. I tried updating wiringpi anyway and found there was an update available, which surprised me since I thought I'd already updated it to the 4B version. Unfortunately the update made no difference to my erratic buttons. I can't see anything else that I've installed that might interfere with sbpd. At this point I think I'll try a fresh install of pCP6 on the 4B 4GB, just to rule out any messed up libraries etc on my main server. ------------------------------------------------------------------------ chill's Profile: http://forums.slimdevices.com/member.php?userid=10839 View this thread: http://forums.slimdevices.com/showthread.php?t=107001 _______________________________________________ diy mailing list diy@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/diy
