Garey Barrell <[EMAIL PROTECTED]> made an utterance to the drakelist gang
----------------------------------------------------------------------
What serial number unit? Pin 6 should have ~100V R or T.
73, Garey - K4OAH
Glen Allen, VA
Drake 2-B, 4-B, C-Line & TR-4/C Service Supplement CDs
<www.k4oah.com>
[EMAIL PROTECTED] wrote:
On V7, Pin 7 shows 1.13v receive, 148 transmit and pin 6 shows 250v
receive and transmit.
In a message dated 3/31/2008 3:34:54 P.M. Eastern Daylight Time,
[EMAIL PROTECTED] writes:
Garey Barrell <[EMAIL PROTECTED]> made an utterance to the
drakelist gang
----------------------------------------------------------------------
Have you checked voltages on V7? Is it being cut off in transmit?
73, Garey - K4OAH
Glen Allen, VA
Drake 2-B, 4-B, C-Line & TR-4/C Service Supplement CDs
<www.k4oah.com>
[EMAIL PROTECTED] wrote:
> I am still working on my TR-4C. I now have the filter problem fixed
> and in fact have the correct signal going all the way to the 12BY7
> driver tube. I do not have any signal coming out of the driver
to the
> finals. The tube is good and I have substituted another with no
> change. The voltages all check good on the 12BY7 except for pin
8. It
> has the full 250 volts on it so no grid current is flowing
there. What
> might cause this? Has any one out there run into this problem
before
> and maybe could tell me where I should look for the problem. As
always
> any help would be appreciated. Thanks and 73,
>
Terry
> W8NJR
>
>
>
>
----------------------------------------------------------------------
Submissions: [EMAIL PROTECTED]
Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body
Hopelessly Lost: [EMAIL PROTECTED] - help in body of message
Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net
----------------------------------------------------------------------