Garey Barrell <[EMAIL PROTECTED]> made an utterance to the drakelist gang
----------------------------------------------------------------------
10.400 MHz ??
[EMAIL PROTECTED] wrote:
OK Garey, I must have been on the wrong pin before. The voltages on V7
are all ok and close to where they should be in R & T. I have a scope
(Tetronix) and a Freq. counter. I am testing with the bandswitch in
the 20m position. On pin 2 of V6 I show a freq of 10.400 mhz when I go
to T and when I talk in the mike I can see the SSB signal there.
Still, nothing on the other side of V6 tho. No RF there.
Terry
In a message dated 3/31/2008 4:21:47 P.M. Eastern Daylight Time,
[EMAIL PROTECTED] writes:
Garey Barrell <[EMAIL PROTECTED]> made an utterance to the
drakelist gang
----------------------------------------------------------------------
OK. That's Version 1. V7 circuit is the same though. Voltage
divider
on Pin 6, screen of V7, voltage should be ~100V R or T. Likely
not the
current problem though. Perhaps you were looking at Pin 5?
You say you have signal to the grid of V6. Is that ON Pin 2 or
?? Are
you looking with a scope or ??
----------------------------------------------------------------------
Submissions: [EMAIL PROTECTED]
Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body
Hopelessly Lost: [EMAIL PROTECTED] - help in body of message
Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net
----------------------------------------------------------------------
