False Alarm I had DXB open which appeared to create a permissions conflict rather than tell me the database was in use. Typical MS :)
The Host file relocation went OK so I think everything is working under vista.... And before anyone asks why I went with VISTA I felt by the end of the life cycle it would be like trying to run under WIN98 on a PC today. I hope I'm right. Thanks again everyone Paul VE3SY -----Original Message----- From: Paul Cassel [mailto:[EMAIL PROTECTED] Sent: July-22-08 7:50 AM To: 'Paul Cassel'; 'Jack' Cc: 'DXbase' Subject: RE: [Dxbase] VISTA and DXb 2006 Well I guess I spoke to quickly. I was able to access the VE3SY.MDB start-up database but having no end of grief with the ANAL permissions in VISTA that will not allow me to unzip the MDB records into the DXB folder. I know this is more of a VISTA thread than DXB however I expect others have been here too. Any suggestions Paul -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Paul Cassel Sent: July-22-08 7:23 AM To: 'Jack' Cc: 'DXbase' Subject: RE: [Dxbase] VISTA and DXb 2006 OK Jack - all working now I was using the 2004 .REG file so I simply exported the Registery entry from my previous notebook as VE3SY.reg to a shared directory on my new Dell. I ran the new .REG file and it installed itself in VISTA. Thanks for suggesting too check the .REG file 73 Paul VE3SY -----Original Message----- From: Jack [mailto:[EMAIL PROTECTED] Sent: July-22-08 5:53 AM To: Paul Cassel Subject: Re: [Dxbase] VISTA and DXb 2006 Paul, Are you actually using the correct registration file for DXbase 2006? We have had reports like yours where the user says they did everything correctly, got the correct response indicating that the registry was updated, but still the program stayed in trial mode. In every case, it turned out that the user was using an old registration file for the wrong version. I am assuming you are not using 64bit Vista. Regards, Jack ----- Original Message ----- From: "Paul Cassel" <[EMAIL PROTECTED]> To: "'DXbase'" <[email protected]> Sent: Monday, July 21, 2008 8:22 PM Subject: [Dxbase] VISTA and DXb 2006 >I have not seen any feedback relative to VISTA and DXB 2006 other than from > Gary AL9A who has the identical Dell Notebook and reported all OK > > > > * I was logged in as Admin > * I right clicked on the Set-Up and selected Run as Administrator > * DXB loaded and ran fine in Demo Mode > * I then ran the CALL.REG registration key and replied to the Anal > Vista warnings and it reported that the registry was updated > * Started DXB and it still indicates not registered. > > > > Any suggestions guys? The reference in the archives to 64 bit does not > match my registry layout and so I assume it is not applicable? > > > > Paul VE3SY > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
