After an interrupted build K2 / 4313 nearing completion but have run into
trouble at the first stage of 40-Meter Transmitter Alignment (Page 75).
Elecraft Dummy Load connected.
Frequency set to display 7100 KHz
Power Output set to 2.0W
Holding 'Tune' there is a momentary burst of side-tone then in turn the display
shows:-
1) Elecraft
2) 2.04P 1.09
3) 7100 KHz
But no evidence of transmit power.
Tapping display shows 13.5 / 0.22.
Guess I've done something stupid --- any suggestion appreciated.
Bill Scovell / VK4SQ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
