Good evening all, just making my way through the K2 build and had was wondering
about some resistance check results. On R115 and U1 pins 4,9,10,28 I am getting
readings in the range of 3.9 mega ohms to 5.4 mega ohms. The results sheet
advise of results in and around 20k. In the past I have found that the measured
amount was somewhat close to the expected manual. To me it just seems a bit
high when you are to see greater than 20K and the measured amount is in the
Mega ohms....is this normal?The last measurement question I have is for R1 and
R2. I have to see 1mega ohm or more and my Fluke is just reading OL....is this
what I am looking for?The only "normal" reading in this check out to me is U1
pin 1 which comes in at 4.85K Thanks for your
timeMikehttp://elecraftk2.blogspot.ca/
Exact readings I am gettingR115 9.57mega ohmsU1Pin 4 3.9
mega ohmsPin 9 4.8 " "Pin 10 4.7 "
"Pin 28 5.4 " "
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
