The user book says 14vdc... I have a reg. power supply that does,15.000 vdc. Is that going to be a problem? Phil
Non judgement day is near On May 10, 2013, at 7:02 PM, Mike Weir <[email protected]> wrote: > Good evening all, just making my way through the K2 build and had was > wondering about some resistance check results. On R115 and U1 pins 4,9,10,28 > I am getting readings in the range of 3.9 mega ohms to 5.4 mega ohms. The > results sheet advise of results in and around 20k. In the past I have found > that the measured amount was somewhat close to the expected manual. To me it > just seems a bit high when you are to see greater than 20K and the measured > amount is in the Mega ohms....is this normal?The last measurement question I > have is for R1 and R2. I have to see 1mega ohm or more and my Fluke is just > reading OL....is this what I am looking for?The only "normal" reading in this > check out to me is U1 pin 1 which comes in at 4.85K Thanks for your > timeMikehttp://elecraftk2.blogspot.ca/ > > Exact readings I am gettingR115 9.57mega ohmsU1Pin 4 3.9 > mega ohmsPin 9 4.8 " "Pin 10 4.7 " > "Pin 28 5.4 " " > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
