Wim DeWilder posted:
I have a 31 foot vertical myself (S9 V31) and since I have the KPA500 I
use the 600 WATT MFJ remote auto tuner.
With about 8 radials of 30 ft it works well on 40m - 10m.
The MFJ can't tune it on 80m but the internal K3 tuner does.
Feedline is 100ft of RG213
---------------------
Wim,
Is the MFJ tuner still "in line" when you tune with the K3 on 80 meters?
It seems to me that you are loading a 40 meter vertical on 80 meters, which
means your feedpoint impedance is probably very high--maybe a few thousand
ohms??? That's a pretty large order for most auto-tuners.
The K3 tuner is darn good, and just might give you a match of some sort, but
that's a stretch for it as well. 10:1 is kind of the spec limit, and I
think you may be exceeding that. Still, I'm not sure what it might be
tuning if you don't have the MFJ bypassed.
Also, that 100 feet of feedline, even though it's pretty good stuff, is
probably giving you a lot of loss since you apparently don't have a good
match at the base. As I understand it, if you don't get pretty close to 50
ohms at the base of the antenna, then your coax will just increase your
losses considerably over and above what it would normally cause due to the
length of the run.
I can "tune" my R8 vertical on 80 meters (and even 160 meters) just using
the K3's ATU, and a run of about 50 feet of coax. However, I am certain
that my efficiency is crap! I've only tried this a couple of times because
it scares me to death to try it!
Dave W7AQK
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
