I'm surprised to hear that, Tom. Mine's been in
service since July 1999 (the headphone jack, not
the KSB2!) and no problems. Of course, with a K3
and KX3 the K2 doesn't get much use these days.
Phil W7OX
On 12/6/14 5:57 PM, Tom McCulloch wrote:
I believe a lot of folks have had a problem with
that jack. It sounds (no pun ) like you may
need a replacement
Tom, wb2qdg
K2 1103
On 12/6/2014 8:52 PM, Frank Krozel wrote:
Oh, it was broken and sold that way to me.. In
order to hear “something” out of the speaker,
you have to insert a headphone into the hole
about 1/2 way lol
Frank
On Dec 6, 2014, at 7:49 PM, Phil Wheeler
<[email protected]> wrote:
The headphone jack should be unrelated to the
mic config header and the KSB2 board. Why do
you think you need a new headphone jack, Frank?
Phil W7OX
On 12/6/14 5:47 PM, Frank Krozel wrote:
So guess replacing my “headphone jack” will
be a part of this process as well.
Frank
On Dec 6, 2014, at 7:39 PM, Matt VK2RQ
<[email protected]> wrote:
The “missing” PCB header is supplied with
the KSB2 SSB option module. If you order a
MH2 microphone, you’ll get a packet of
PC-style jumpers to bridge the header.
Otherwise, if you use a different type of
microphone, you need to take care for the
jumping yourself. The “UNPCB” guy sells a
nice jumpering PCB that allows you to easily
change the jumper setup for a range of
standard mics, suggest you look it up below
(look for “Internal Mic Adaptor”):
http://www.unpcbs.com/
73, Matt VK2RQ.
On 7 Dec 2014, at 12:36 pm, Frank Krozel
<[email protected]> wrote:
All I “see” are pc holes that are
unpopulated. I am thinking there is a
header missing or similar.
I was kind of looking for a jumper block.
Frank'
On Dec 6, 2014, at 7:27 PM, Phil Wheeler
<[email protected]> wrote:
Frank, for the K2 (I think that's the rig
you mean) the info you need is in this
document "ELECRAFT KSB2 S SB ADAPTER
Assembly and Operating Instructions". Near
the end is the info for configuring it for
various mics.
When you said "Mine was inoperative when I
got it used" do you mean on SSB or
completely? Does it have the KSB2 option
installed?
73, Phil W7OX
On 12/6/14 5:20 PM, Frank Krozel wrote:
Guys, I am about ready to place an order
to Elecraft and one of the items I will
be needing are a few of the connectors
like P3, P6, and the headphone jack.
Mine was inoperative when I got it used..
Where is the jumper block for the mic?
Been staring at the pictures and cannot
find the manual where it shows where the
jumper block is.
I guess it is on the control panel but
cannot find any picture of that in case I
need some additional connectors.
(I got it used and it is in perfect
condition!!)
Frank KG9H
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
