Frank,
The K2 microphone configuration header is on the back of the Front Panel
Board. See the KSB2 manual for details on the wiring for that header.
If the prior owner did not tell you what the microphone configuration
header is wired for, you will have to do a physical examination of the
header wiring compared to the wiring information presented in th KSB2
manual.
To get to view the microphone configuration header, you must remove the
Front Panel from the K2. That means first removing the top cover (or
KPA100), and then removing the KAF2 or KDSP2 options (if present) from
the Control Board. There will be either a standoff or a 4-40 screw
securing the Control Board to the standoffs behind the front panel.
Once those connections between the Control board and the Front Panel
board are removed, the Front Panel can be freed by removing the 4 screws
holding the FPB to the K2 side panels and pulling the FPB forward.
Trace the wiring on the Microphone Configuration Header to determine if
your particular microphone is wired correctly (see the KSB2 manual).
That should allow you to set your K2 to the microphone which you are
trying to use with the K2,
73,
Don W3FPR
On 12/6/2014 8:20 PM, Frank Krozel wrote:
Guys, I am about ready to place an order to Elecraft and one of the items I
will be needing are a few of the connectors like P3, P6, and the headphone
jack. Mine was inoperative when I got it used..
Where is the jumper block for the mic? Been staring at the pictures and cannot
find the manual where it shows where the jumper block is.
I guess it is on the control panel but cannot find any picture of that in case
I need some additional connectors.
(I got it used and it is in perfect condition!!)
Frank KG9H
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
