Hello Elecraft, When feeding the audio from the K3S USB port to the CPU, the K3S audio level is extremely high and way too hot for good performance on many digital modes. Example, even with my CPU's sound card set at the lowest possible level of "01" my K3S is hitting the JT-65 software with a super strong signal that is much higher than the software wants to see and performance is degraded. The same is true when operating RTTY using MMTTY or 2Tone software. The USB audio output on the K3S needs to be adjustable in the K3S Menu as it was on the K3 Serial port. I wrote to you a few months ago about this without a positive reply. Please address this serious issue. Thank you- Richard Van Zandt- K9OM In a message dated 6/2/2017 7:28:48 P.M. Central Daylight Time, [email protected] writes:
If you are using Line Out with a fixed gain setting to feed audio to WSJT-X, adjusting the AF control will not do anything. What I do is leave my RF gain control at its normal position (around 3 o'clock) and use the slider at the lower left in the WSJT-X window to compensate for gain variations. 73, Rich VE3KI W3FPR wrote: > Bret, > > You may have better luck with running the RF Gain full and adjusting > with the AF gain. That way the RX AGC will smooth out variations in the > signal level. > > 73, > Don W3FPR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
